Basic Control for RW Configuration

Basic Control for RW Configuration

    • Water Pump   

      • Protected against running dry according to DIN EN 13053-6.8.3.3
      • Thermic protection switches pump off in case of overheating and sends an alert to the control panel
      • Water level detector provides additional protection
    • Water Level Detector   

      • Low: Pump is stopped if water goes below the low water control level
      • High: Filling valve is closed when water reaches the high water control level
    • Drain Valve   

      • Control panel can switch drain valve on/off
      • Drain valve controls basin emptying and water deconcentration (or bleed-off)
      • Deconcentration cycles can be adjusted by timer or evaporated volume method
    • Multiple-Stage Control   

      With an RH sensor and solenoid valve(s), the EvaPack™ control panel can adjust water distribution on pad cassettes. Up to 4-stage control.

    • Stages Watering Control With Bypass Damper   

      With an RH sensor and solenoid valve(s), the EvaPack™ control panel can adjust water distribution on pad cassettes and a proportional motorized damper.

    • Optional Controls   

      • Filling water pretreatment by U.V. lamp with 50μm and 5μm water filters
      • Air relative humidity sensor
      • Air temperature sensor
      • Water temperature sensor
      • Water conductivity sensor

    Basic control for RW configuration system.

    Basic control for RW configuration system.

    Multiple stages control for RW configuration system.

    Multiple stages control for RW configuration system.

    Multiple stages control for RW configuration system with by-pass damper.

    Multiple stages control for RW configuration system with by-pass damper.

Learn More About Armstrong's EvaPack™ Series